AES Semigas

IQE

27 July 2020

Silicon carbide transistors improve efficiency in home storage systems

To meet the evolving needs of climate change and the German energy transition, as well as combat the rising energy costs for end consumers, more and more households are adding home storage systems to their photovoltaic (PV) systems. A major challenge of PV home storage is that the batteries are charged within a few hours in intense sunlight and then discharged at very low power, or partial load, over a long time period during the night. Because of this, battery inverters in home storage systems should have high conversion efficiency over the largest power range possible. In the HyBaG project, which started in 2017, the Fraunhofer Institute for Solar Energy Systems ISE in collaboration with Siemens-owned inverter manufacturer Kaco New Energy and STS - Spezial-Transformatoren Stockach has developed a low-loss hybrid inverter that functions efficiently even at partial load. With the new inverter, private households can save up to €250 annually.

Energy storage systems can make an important contribution to renewable energy storage, grid stability and reducing CO2 emissions. For this, the systems must be optimized in terms of efficiency, costs and use of resources on a continual basis, notes Fraunhofer ISE. The HyBaG project partners have therefore developed a demonstrator of a photovoltaic home storage system meeting the highest requirements.

In this project, Fraunhofer ISE developed highly efficient compact battery chargers including innovative control technology. A central component of its work in the project was to develop compact and modular battery controllers. This could be achieved by using gallium nitride (GaN) and silicon carbide (SiC) power components. These transistor bridge circuits are the core of modern battery chargers and enable increasingly faster switching with lower losses.

Optimization of partial load efficiency

In the project, various approaches to optimize the partial load efficiency were examined by simulation. Prototypes were then constructed using the best resulting concepts. Both the hardware as well as the control software for the power electronics were optimized. Different circuitry topologies were investigated and their partial load efficiencies were evaluated at low power levels.

Considering various parameters, an interleaved converter for the high-voltage battery controller was selected and constructed. This makes it possible to specifically adjust the power range to one-third, two-thirds or full nominal power by activating or deactivating individual converter bridges.

For very low power levels, an additional operating mode (gap limit mode) with variable switching frequency and minimum possible losses and a pulsating mode (burst mode) with one phase in which the converter is active only 10% of the time. “This can significantly increase the partial load efficiency, as it reduces the control and no-load losses that strongly influence the efficiency in the partial load range,” says Cornelius Armbruster, project manager at Fraunhofer ISE.

If not all phases are operated at the same time, it is recommended that the individual phases be operated alternately in order to achieve a uniform thermal load. The modulation method showing the best efficiency differs depending on the power range. Within the project, operation management, whose efficiency was optimized for the different power ranges, was developed and implemented.

Savings potential through optimization of partial load efficiency

In series production, home storage systems based on silicon carbide components can be put on the market today at nearly no additional cost. At present, the optimization of efficiency during partial load operation is seldom carried out. A rough comparison of the available home storage systems on the market shows that considerable differences between the systems still exist.

“A major factor behind these differences is the losses in the partial load range,” says Leonhard Probst, who is responsible for optimization of the battery charger in the project. Very good home storage systems have fewer losses. Simulations performed in the HyBaG project estimated that annual electricity savings of €150-250 can be expected.

The battery team at Fraunhofer ISE remains in close contact with manufacturers of battery storage systems with the aim of demonstrating the potential for optimization and accompany developments in this field of technology.

Tags: Fraunhofer ISE Power electronics

Visit: www.elektronikforschung.de/projekte/hybag

Visit: www.ise.fraunhofer.de

RSS

Picosun